Brenden
- Total activity 576
- Last activity
- Member since
- Following 0 users
- Followed by 2 users
- Votes 2
- Subscriptions 304
Articles
Recent activity by Brenden-
What brake fluid should I use in my CB450 / CL450 / CB500T?
DOT 3 brake fluid.
-
What is the valve adjustment / tappet clearance specs for the Honda CB450 / CL450 / CB500T?
From the factory the CB450 / CL450 / CB500T Intake & Exhaust was set and listed at: Factory: 0.03 mm (0.0012" in.) Over here at Common Motor we have found through experience this value to be way t...
-
How often should I change my front fork oil on my CB450 / CL450 / CB500T?
Every 5,000 miles / 8,000 km or once a year, whichever comes first
-
What type of fork oil and how much fork oil should I use in my CB450 / CL450 / CB500T?
We recommend a 10W (light rider) to 15W (heavy rider) motorcycle fork oil. ATF is approximately 5W and replacing it with a heavier weight oil will stiffen up your front end. Factory spec on the for...
-
How often do I need to replace the ignition points on my CB450 / CL450 / CB500T?
Inspect and set every 1,500 miles / 2,400 km. Consider replacing after 6,000 miles / 9,600 km.
-
How do I set the ignition timing on my CB450 / CL450 / CB500T?
If you have not, before setting your ignition timing be sure to also: How to set the valve adjustment & cam chain tension on the Honda CB450 / CL450 / CB500T This is step by step of how to prope...
-
How often do I need to set the ignition timing on my CB450 / CL450 / CB500T?
Every 1,500 miles / 2,400 km.
-
What is the carburetor float height for my Honda CB450 / CL450 / CB500T?
CB450 / CL450: Approximately 20mm
-
What are the carburetor stock size jets for my Honda CB450 / CL450 / CB500T?
The Honda 450 family bikes went through various main changes over the years of production and here are the jet sizes to the best of our knowledge. We have seen combinations of following: Main Jet P...
-
How often should I lubricate and inspect the drive chain on my Honda CB450 / CL450 / CB500T?
Lubrication and inspection of the drive chain should be happening every 500 miles / 800 km. The maximum slackness when measured by moving the drive chain vertically is 1 to 2 cm (0. 4~0. 8 in)