Brenden
- Total activity 576
- Last activity
- Member since
- Following 0 users
- Followed by 2 users
- Votes 2
- Subscriptions 304
Articles
Recent activity by Brenden-
What is the correct tire air pressure for my for my CB360 / CL360 / CJ360?
Front Tire Pressure: 26 psi / 1.8 kg/sq. cmRear Tire Pressure: 28 psi / 2.0 kg/sq. cm
-
What size tires do I need for my CB360 / CL360 / CJ360?
Front Tire: 18-100/90 (modern sizing) / 3.00-18 (old sizing)Rear Tire: 18-110/90 (modern sizing) / 3.50-18 (old sizing)
-
What is the fuel capacity of a CB360 / CL360 / CJ360?
CB360: 2.7 U.S. gal., 11.0 lit., 2.2 Imp. gal. CL360: 2.4 U.S. gal., 9.0 lit., 2.0 Imp. gal. CJ360: 3.7 U.S. gal., 14 lit., 3.1 Imp. gal.
-
What fuel should I use in a CB360 / CL360 / CJ360?
We recommend premium (92+ octane) fuel; if it can be found non-ethanol fuel as well.
-
How often do I need to change the engine oil on a CB360 / CL360 / CJ360?
Every 1,500 miles / 2,400 km.
-
How much engine oil do I need for my CB360 / CL360 / CJ360?
When changing oil: 1.5L (1.6qt.)When separating the crankcase: 2.0L (2.1qt.) *Always check the dipstick for an exact reading. To check the oil level, unscrew the dipstick and wipe it off. set the d...
-
What engine oil should I use for my CB360 / CL360 / CJ360?
Recommended oil viscosity for general riding and all temperatures is: SAE 10W-40. We recommend adding 2oz. of Zinc ZDDP additive per quart of oil with every oil change. We've also had success runni...
-
What type of fork oil and how much fork oil should I use in my CB350 / CL350 / SL350?
The fork oil should be changed every 4-5,000 miles. Factory spec on the fork oil is of premium quality ATF (automatic transmission fluid), however we recommend a 10W (light rider) to 15W (heavy rid...
-
What is the carburetor float height for my Honda CB350 / CL350 / SL350?
CB350 / CL350: 19 mm (Early Style Square Float) 24 - 26 mm (Late Style Round Float)SL350 K1-K2: 26 mm (round slide carb)
-
How often should I lubricate and inspect the drive chain on my Honda CB350 / CL350 / SL350?
Lubrication and inspection of the drive chain should be happening every 500 miles / 800 km. Maximum slackness when measured by moving the drive chain vertically is 10 to 20mm (0.4 to 0.8 inches).