Brenden

We have a variety of wiring diagrams for all of our bikes posted on our Manuals Page, but in case you have any doubt about how to hook up the factory contact point ignition system (generally common...

The Camshafts and rocker arms found in Honda CB350 , CB360, CB450 & CB550 are prone to premature wear and damage. The good news is that they can be rebuilt and put back into service! We show some ...

The standard valve clearance is: Intake: .05 mm (0.002" inch) Exhaust: .10 mm (0.004" inch.)

Gap specification: 0.7 - 0.8 mm (0.028 - 0.032 in.)

We recommend premium (92+ octane) fuel; if it can be found non-ethanol fuel as well.

This is step by step of how to properly set points and ignition timing on the Honda CB350, CB360, CB450 and CB500T family of motorcycles. Ignition timing must be set every 1500 miles (2400 km) for ...

Spark plugs are available in various heat ranges. Select plugs from a heat range that suits the load and temperature conditions under which your bike will be run. As a rule of thumb, use the highes...

    The engine oil is the chief factor affecting the performance and service life of your engine. Use only the recommended oil, and ensure oil is maintained at the proper level. Plan on changing t...

For general degreasing we use Black Scorpion and Purple Power, but any water-based degreaser should do the trick. Our parts washer uses specific parts washer fluid that is a petroleum-based industr...

The Honda 350 family bikes went through various jetting changes over the years of production and here are the jet sizes to the best of our knowledge. We have seen combinations of all of these: Ma...