CMC Shockwave Installation Pt1 : Component Parts & Module Bracket Assembly

Rough Draft of Shockwave Installation Instructions: See Notes Below

-Index mark lines on the sensor plate represent 5 degrees of crankshaft rotation for each mark.

-Trigger Module Wire Layout:

Black = Ground

Red = 12V +

White = Negative side of coil (yellow or blue wire on the coil where the condenser would plug into)

Green / Blue = sensor (green / blue)

-It is recommended to position the trigger modules as follows to keep the orientation consistent on the bike. This will correlate with the sensor positions and cylinders

Left Cylinder / Coil / Sensor = Blue

Right Cylinder / Coil / Sensor = Green

-At this time we do not have a module mounting diagram per bike frame. Please experiment with the configuration and find the one that works best for your bike and send photo documentation.